Line up the two 4-foot lengths of wood (from here on out referred to as the back planks) with one of the pre-drilled 16-inch slats, starting at what will be the top of the seat back. The top edge of the slat should be flush with the end of the 1-inch side of the plank, and the end of the slat should be flush with the wider 3-inch side of the plank. Use a T-square to line up the slat and the plank in a perfect 90-degree angle.
Alinhe os dois comprimentos de 4 pés de madeira (de aqui sobre para fora referido como as pranchas de trás) com um dos slats 16 polegadas pré-perfurados, começando com o que vai ser a parte superior do encosto do banco. A borda superior do slat deve ser alinhada com a extremidade do lado da prancha de 1 polegada, e o fim do slat deve ser alinhado com o lado de 3 polegadas mais largo da prancha. Use uma régua t para alinhar o slat e a prancha em um ângulo de 90 graus perfeito.